Hall elevator

To improve the accessibility of the building, an elevator has been installed in the entrance hall. It will allow us to save the steps that separate the entrance of the building from the lift.

To use it, it is necessary to insert the smallest key from the key ring we have provided you with into one of the 3 locks it has and keep it turned a quarter of a turn clockwise during the whole movement. If we release the key, the movement stops.

When we operate one of the external locks of the hoistway (the ones outside the hoistway), the hoistway will move up or down, to approach the place from where we are operating it. During the lock operation time, the lock remains illuminated in red. Once the lift is next to us, the access door can be opened.

imagen-4

  1. If we are at the top and the hoistway is at the bottom, when the key is operated, the hoistway will go up to the top.

  2. If we are at the bottom and the hoistway is at the top, when we operate the key, the hoistway will go down to us.

  3. If the elevator is next to us and we activate the key, the hoistway will not make any movement.

Once the elevator is next to us, the door can be opened, so that we can enter it. Once inside, to go up or down, we will have to insert the key again in the interior lock, turn it, and simultaneously hold down the button that takes us to the desired floor:

0: Exit the building

1: Ascent to the lif

  • KEY + 0 Simultaneously. We go down to the exit
  • KEY + 1 Simultaneously. We go up to the entrance of the lift

If the key is released or the button is not pressed, the lift stops.

imagen-5

The hoistway access doors can only be opened when the hoistway is in the correct position.